The main step in the production of biological Manure is the fermentation of raw materials. The use of reasonable raw material ratio and good fermentation strains can increase the content of microorganisms in Manure. In addition, the control of temperature during the fermentation process is also very critical. When the temperature reaches about 70 degrees, the Manure dumper should be used in time to dump materials to avoid excessive temperature and make materials fully contact with the air, Provide favorable conditions for the survival and reproduction of beneficial microorganisms. Therefore, the quality of Manure produced by us will be better.

Use Manure tipping machine to ferment raw materials:

1. A slot type tipping machine is required, and a fermentation tank with a width of 3 meters and a length of 50 meters (capable of fermenting over 200 tons of raw materials) needs to be built, which can also achieve multi tank operation with one machine.

2. Then stack the raw materials of Manure (excrement, biogas residue, straw) in the fermentation tank, mix 1kg humic acid with 20kg water, and mix with the raw materials. 1kg humic acid can ferment 1t raw materials. Mix according to the comparison of raw materials, and the temperature is about 40-60 ℃. 3. The fermentation cycle is 7-10 days, flipping and throwing once every 2 days can completely decompose. (At this point, a slot type stacker can be used)

3. After fermentation, Manure mixer, semi wet material grinder, Manure granulator, dryer, cooler, screening machine, etc. are also needed for the next step of processing.

Fermentation characteristics of biological Manure tipping machine equipment:

1. Suitable for aerobic fermentation and can be used in conjunction with solar fermentation chambers, fermentation tanks, and transfer machines. It can achieve the function of multiple slots for one machine when used in conjunction with a mobile device.

2. The fermentation tank matched with it can both continuously discharge and batch discharge. High efficiency, stable operation, sturdy and durable, even flipping and throwing.

3. The control cabinet is centrally controlled and can achieve manual or automatic control functions.

4. Equipped with a soft starter, low impact load during startup.

5. Equipped with a gear extraction and pressure lifting system.

6. The tooth extraction is sturdy and durable, with a certain ability to break and mix materials.

7. The limit travel switch plays a limiting and safety role.